Motor Mounts
 Bottom View
| Motor mount using stock plywood mounts. Pin them in place and take the
cross-shaped frame to them. After, wrap the joint with thread and soak it with thin CA. The ball in the middle is
from a craft shop and is made for beading and such. Drill them to the diameter of the shafts and then glued
them in place with medium CA.
| The angled pieces are .070" carbon fiber rods which keep each of the mounts from twisting sideways. I did not bind these, because I would prefer that these give way under a severe impact. They will be very easy to re-glue in place; a lot easier to fix than most other other parts of the frame.
| |
